Attic Duct Cleaning Midvale UT is the job of pulling years of dust, insulation fibers and pest debris out of the supply runs that feed your upstairs bedrooms. If your upper level smells musty when the furnace kicks on, or your kids wake up congested every morning, the attic trunk line is usually the reason. We run a duct camera first, show you the footage, then clean it.
Attic Duct Cleaning Midvale UT is a source-removal service that strips settled dust, rodent droppings, insulation fibers and mold spores out of the flexible and sheet metal duct runs routed through your attic. We cut access at the plenum, run a rotary brush and air whip through each branch line, then pull everything back through a negative air machine fitted with HEPA filtration. Register covers come off, get washed, and go back on. Every run is documented on camera before and after.
Midvale sits in Salt Lake County where attic temps swing from below freezing in January to 140 degrees Fahrenheit by July. That thermal cycling cooks flexible duct, dries out duct insulation, and cracks mastic at the joints. Add the valley's inversion-season dust and you get attic duct cleaning service Midvale UT homeowners book every three to five years. If you are searching attic duct cleaning near me Midvale and your upstairs registers puff gray dust, that is the call.
Every attic duct cleaning in Midvale, Utah starts with camera inspection and ends with resealed joints and a written report. The list below covers the standard scope. Duct replacement, new attic insulation and full HVAC coil cleaning are quoted separately once we see the camera footage.
We run a duct camera through the plenum and every accessible attic branch, then show you the monitor. You see debris depth, disconnected joints and any pest evidence before we quote the cleaning. This step takes 20 to 30 minutes and is included in every job.
A negative air machine with HEPA filtration ties into the trunk and holds the attic at negative pressure for the whole job. Particles down to 0.3 microns stay contained. Nothing we loosen migrates into your upstairs bedrooms while we work.
Flexible duct rod with a rotary brush handles the branch runs. Air whip and compressed air nozzle work clear the larger sheet metal trunks and tight elbows. We work from the farthest register back toward the plenum so debris exits rather than packs.
After extraction we apply an EPA-registered sanitizer to the cleaned runs. If the camera showed mold growth in ducts, we treat those sections with an antimicrobial product and document the application in your report.
Every register cover comes off, gets washed and dried, then goes back on. The grille is the last place dust collects before air enters the room, so skipping this step undoes half the cleaning.
We reseal every joint we opened with duct sealant, mastic and foil tape, then re-run the camera and check static pressure at the plenum. You get before-and-after footage plus a written summary of what was cleared and what to watch.
We start with a duct camera through the main plenum and each accessible branch. You see the footage on the monitor. We note debris depth, disconnected joints, crushed flexible duct, and any pest evidence. This takes 20 to 30 minutes and tells us exactly which runs need the rotary brush versus the air whip.
We tie a negative air machine with HEPA filtration into the trunk line and seal the registers. That keeps the attic at negative pressure so nothing we loosen ends up in your living room. Abatement Technologies HEPA units capture particles down to 0.3 microns, which covers mold spores and most rodent allergens.
Each branch gets a flexible duct rod with a rotary brush, followed by an air whip on the larger sheet metal runs. Compressed air nozzle work handles the tight elbows where debris packs hardest. We work from the farthest register back toward the plenum so nothing gets pushed into a dead end.
Once the runs are clear, we apply duct sealant and mastic at every joint we opened, then re-tape with foil tape where the original connection failed. Register covers get washed and reinstalled. If we found mold growth in ducts, this is the stage where the antimicrobial treatment goes down.
We re-run the camera, show you the after footage, and check static pressure at the plenum. You get a written summary of what we found, what we cleared, and what to watch. If a run needs replacement rather than cleaning, we tell you that instead of billing you for a cleaning that will not hold.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Creates negative pressure in the duct system and captures particles down to 0.3 microns. Keeps attic debris out of your living space for the entire job.
Mechanically scrubs the inside walls of flexible and sheet metal branch runs. Reaches the full length of a typical attic branch from a single access point.
Loosens packed debris in larger trunk lines and tight elbows where a brush cannot reach. Used after brushing to flush remaining material toward the extraction point.
Documents conditions before and after cleaning. We show you the footage on-site so you can see exactly what was removed and what was left alone.
Commercial-grade filtration for jobs with mold or heavy pest contamination. Standard equipment on every attic cleaning, not an upgrade.
Specialty cleaning heads for different duct materials. We match the tool to flexible duct versus sheet metal so we clean without damaging the liner.
A Midvale Heights homeowner reported a musty smell and visible dust at the upstairs registers. Camera footage showed a mouse nest about six feet into the main attic trunk, plus droppings along two branch runs and a disconnected joint near the plenum.
We removed the nesting material and debris, sanitized the affected runs with an EPA-registered product, and resealed the disconnected joint with mastic and foil tape. Static pressure at the plenum dropped by 0.12 inches of water column. Register dust stopped within the first heating cycle.
A 2004 two-story had two upstairs bedrooms that never reached setpoint. Camera inspection found two flexible duct runs crushed nearly flat where they turned around roof framing, plus torn insulation on a third run. The furnace was running 20 minutes longer per cycle than it should.
We replaced the two crushed sections with properly supported flexible duct, repaired the torn insulation, and cleaned all 12 branch runs. The farthest register improved by 8 degrees Fahrenheit. The homeowner reported the furnace cycling normally within a week.
A seller in Fort Union had a buyer's inspection flag visible dust and debris in the attic supply runs. The home had no documented duct cleaning history and the buyer's agent was requesting a price concession.
We completed a full attic duct cleaning in Midvale, Utah within 48 hours of the call, provided before-and-after camera footage, and issued a written cleaning summary. The buyer withdrew the concession request and the sale closed on the original schedule.
Most attic duct calls start with one of four complaints: dust, smell, uneven heat or a pest problem. Each one traces back to the same source, and each one is fixable.
Ask a pro →We pull the debris out at the source with a rotary brush and negative air HEPA extraction, then reseal the joints so new attic dust cannot get pulled back in. Most Midvale homes stop seeing register dust within the first heating cycle.
We camera-inspect the suspect runs, remove the contaminated material, and apply an EPA-registered antimicrobial treatment. If the duct insulation is saturated, we tell you it needs replacement rather than cleaning.
We clear the restriction, repair crushed flexible duct sections, and reseal the joints to cut static pressure. Midvale customers typically see a 5 to 9 degree improvement at the farthest register after cleaning.
We remove the nesting material, sanitize the affected runs, and seal the entry points we can reach. For heavy infestations we coordinate with a pest control partner before the ducts go back into service.
Most Midvale attic duct cleanings run $350 to $850 in 2026, depending on how many runs feed your upper level and how bad the debris is. A single-story ranch with six branches sits at the low end. Two-story homes in Bingham Junction with 12 or more runs, pest contamination or mold treatment land at the top. Camera inspection and resealing are included in that number.
Every three to five years for most Midvale homes, and every two years if you have pets, allergies or a rodent history. The valley's inversion dust and the attic heat cycling both accelerate buildup. If you have never had it done and your house was built before 2000, book an inspection first. The camera tells you whether you actually need the full cleaning.
A standard job includes camera inspection, negative air setup, rotary brush and air whip cleaning of every accessible branch, sanitizing, register cover washing, and resealing of all opened joints. Duct replacement, new insulation and full HVAC coil cleaning are separate line items. We tell you which category your attic falls into after the inspection, not after the invoice.
Yes, measurably. Removing the dust, dander and mold reservoir inside the attic runs drops airborne particulate in upstairs rooms, often by half within a week. Households with allergy sufferers notice the difference first. Pair it with a quality HEPA filter at the furnace and you hold that improvement between cleanings.
Air Duct Cleaning Near MeFull-system air duct cleaning covers the main trunk and lower level runs that feed off the same plenum as your attic branches. Booking both in one visit saves a second trip charge and gets the whole system on the same cleaning cycle.Explore →
24/7 Air Duct CleaningAttic duct problems do not wait for business hours. Our 24/7 line handles after-hours calls for rodent infestations, musty odors that appear overnight, and post-storm water intrusion into attic duct runs across Midvale and Salt Lake County.Explore →
Emergency Air Duct CleaningWhen a rodent dies in an attic trunk or a roof leak soaks your duct insulation, you need same-day response. We dispatch an emergency crew, isolate the affected run, and get the air in your upper level safe to breathe again.Explore →Residential Air Duct CleaningOur residential service covers single-family homes, townhomes and duplexes throughout Midvale. Attic duct cleaning is the most common add-on because upper level runs collect the most debris and are the hardest for homeowners to inspect themselves.Explore →
Commercial Air Duct CleaningMidvale commercial buildings with rooftop units and exposed attic ductwork need the same source removal on a scheduled basis. We work after hours so your tenants or staff are not disrupted during business hours.Explore →
HVAC Duct CleaningHVAC duct cleaning addresses the full distribution system, including the return side that pulls air back to the furnace. If your attic supply runs are dirty, the returns usually are too, and cleaning both keeps the system balanced.Explore →
Furnace and Duct CleaningCleaning the furnace cabinet and blower wheel alongside your attic ducts stops the equipment from re-contaminating the runs you just cleared. We pull the blower, clean it, and check the heat exchanger while we are in the attic.Explore →
Air Vent CleaningRegister and vent cleaning handles the grilles and diffusers at the point of delivery. It pairs with attic duct cleaning because the last three feet of every run collects the heaviest dust right behind the vent cover.Explore →Call (855) 927-7517 and we will get a camera inspection on the calendar, usually within 48 hours. You see the footage before you approve anything. Licensed, insured, and flat-priced before we start.
Schedule inspection (855) 927-7517 →Call (855) 927-7517 or email [email protected] and we will get you a flat quote, usually within the hour during business hours. We run same-day and next-day slots across Midvale and Salt Lake County. If you have an after-hours emergency, the phone line stays open.